Configure Installed Commands

Enable Commands on the Site

  1. Navigate to "Administer → Plugin Settings"
  2. Click on "Command Configurations"
  3. Enable all commands.

Enable Commands on a Project

Note: You will have to repeat these steps for every project that you intend to enable a Machine Learning workflow on


  1. Navigate to the Project Summary page.
  2. In the "Actions" box, click on "Project Settings"
  3. Click on "Configure Commands"
  4. Enable the requested commands above.

XNAT is an open source project produced by NRG at the Washington University School of Medicine | NRG Home

Contributions to the XNAT Documentation site are licensed under a Creative Commons Attribution 3.0 Unported License. Creative Commons License

$label.name